USB 3.0 A connector CN154
Repair the USB 3.0A connector:
1） Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Lift the CN154 connector from the PCB.
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.
USB type-c connector CN152
Repair the USB type-c connector:
1） Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2）Use a hot air gun to melt the solder on the pins.
3) Lift the CN152 connector from the PCB.
4) Place the new component on the circuit board. Be sure that it matches the footprint.
5) Solder the new component
To Next Page
Loading...
