HPE 3PAR StoreServ 8000

Controller node LEDs
This information applies only to the controller nodes for the HPE 3PAR StoreServ 8000 Storage system.
IMPORTANT: The controller nodes in the controller node enclosure are inverted 180° from each
other, as well as the ports.
Figure 92: Controller node LEDs, controller node enclosure rear view
Table 24: Controller node LEDs, controller node enclosure rear view
LED Function Status State
Status Green solid Not a cluster member
Green rapid flashing
• Booting
• Shutdown (halted)
Green slow flashing Cluster member and flashes slowly in
synchronization with the other controller
nodes in the cluster
UID/Service Blue solid Shutdown (halted); not a cluster member;
can be removed
Blue flashing Locate active; do not remove component
Off Locate not active
Fault Amber solid Fault
Amber flashing In the cluster, one of the other controller
nodes is shut down (halted).
Off No fault
Ethernet onboard ports LEDs, controller node enclosure rear view
The controller node has two Ethernet onboard (built-in) ports:
• MGMT—Onboard port for the network connection
• RC-1—Onboard port for an HPE 3PAR Remote Copy or HPE 3PAR File Persona connection
114 More information