• showport -rcip
• showport -rcfc
• shownet -d
• controlport rcip ping
snmp
Displays issues with SNMP. Attempts the showsnmpmgr command and reports errors if the CLI returns
an error.
Format of possible snmp exception messages
SNMP -- <err>
snmp example
Component -Identifier- ----------Detailed Description---------------
SNMP -- Could not obtain snmp agent handle. Could be
misconfigured.
snmp suggested action
Any error message that can be produced by showsnmpmgr might be displayed.
sp
Checks the status of the Ethernet connection between the service processor (SP) and nodes.
This can only be run from the SP because it performs a short Ethernet transfer check between the SP
and the storage system.
Format of possible sp exception messages
Network SP->InServ "SP ethernet Stat <stat> has increased too quickly check SP network settings"
sp example
Component -Identifier- --------Detailed Description------------------------
SP ethernet "State rx_errs has increased too quickly check SP network
settings"
sp suggested action
The <stat> variable can be any of the following: rx_errs, rx_dropped, rx_fifo, rx_frame,
tx_errs, tx_dropped, tx_fifo.
This message is caused by customer network issues, but might be caused by conflicting or mismatching
network settings between the service processor (SP), customer switches, and the storage system. Check
the SP network interface settings using the SPMaint interface or SPOCC. Check the storage system
settings using commands such as shownet and shownet -d .
task
Displays failed tasks. Checks for any tasks that have failed within the past 24 hours. This is the default
time frame for the showtask -failed all command.
162 Troubleshooting
To Next Page
Loading...
