Figure 95: FC onboard ports, controller node enclosure rear view
Figure 96: FC onboard ports LEDs, controller node enclosure rear view
Table 26: FC onboard ports LEDs, controller node enclosure rear view
LED function Status State
All ports Off Wake up failure (dead device) or power not applied
1 Port speed Off Not connected
3 Fast amber flashes Connected at 8 Gb/s
4 Fast amber flashes Connected at 16 Gb/s
2 Link status On Normal/Connected—link up
Green flashing Link down or not connected
SAS onboard ports LEDs
IMPORTANT: For the SAS DP2 port without an SAS cable attached, the amber LED is illuminated
and the green LED is off. This behavior is expected for the DP2 port. For the SAS DP-1 port without
an SAS cable attached, both amber and green LEDs are off.
The controller node has two SAS onboard ports (DP-1 and DP-2) and each includes two LEDs.
116 More information
To Next Page
Loading...
