HPE 3PAR StoreServ 8000

a. To release the handle into the open position, pinch the latch handle to release the handle into the
open position (1).
b. Extend the latch handle (2).
c. Slide the drive out of the bay (3) and place on an ESD safe mat.
Figure 11: Removing an SFF drive
Figure 12: Removing an LFF drive
Replacement
10. Install the drive.
a. On the drive, press the release button to open the handle.
b. With the latch handle of the drive fully extended, align and slide the drive into the bay until the
handle begins to engage (1).
c. To seat the drive into the drive bay, close the handle (2).
Service 19