6. Remove the bezel from the enclosure front.
a. Unlock the bezel if necessary.
b. Press the release tab.
c. Rotate the bezel away from the enclosure left side.
d. Pull the bezel out from the enclosure right side.
Installation
7. Remove the slot-filler blanks from where you will be installing the pairs of drives.
IMPORTANT: For proper airflow and cooling, a slot-filler blank must remain installed in all
unused drive bays.
8. Install the pair or pairs of drives.
a. On the drive, press the release button to open the handle.
b. With the latch handle of the drive fully extended, align and slide the drive into the bay until the
handle begins to engage (1).
c. To seat the drive into the drive bay, close the handle (2).
Figure 48: Installing an SFF drive
Figure 49: Installing an LFF drive
Verification
Upgrade 63
To Next Page
Loading...
