HPE FlexNetwork 5130 EI Series Configuration Guide

18
To set the maximum number of IGMP snooping forwarding entries:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IGMP-snooping view.
igmp-snooping
N/A
3. Set the maximum number of
IGMP snooping forwarding
entries.
entry-limit
limit
The default setting is
4294967295.
Configuring IGMP snooping port features
Before you configure IGMP snooping port features, complete the following tasks:
• Enable IGMP snooping for the VLAN.
• Determine the aging timer for dynamic router ports.
• Determine the aging timer for dynamic member ports.
• Determine the addresses of the multicast group and multicast source.
Setting aging timers for dynamic ports
When you set aging timers for dynamic ports, follow these guidelines:
• If the memberships of multicast groups frequently change, you can set a relatively small value
for the aging timer of the dynamic member ports. If the memberships of multicast groups rarely
change, you can set a relatively large value.
• If a dynamic router port receives a PIMv2 hello message, the aging timer value for the port is
specified by the hello message. In this case, the router-aging-time or igmp-snooping
router-aging-time command does not take effect on the port.
• You can set the timers globally for all VLANs in IGMP-snooping view or for a VLAN in VLAN
view. For a VLAN, the VLAN-specific configuration takes priority over the global configuration.
Setting the aging timers for dynamic ports globally
Step Command Remarks
4. Enter system view.
system-view
N/A
5. Enter IGMP-snooping view.
igmp-snooping
N/A
6. Set the aging timer for dynamic
router ports globally.
router-aging-time
interval
The default setting is 260
seconds.
7. Set the global aging timer for
dynamic member ports globally.
host-aging-time
interval
The default setting is 260
seconds.
Setting the aging timers for dynamic ports in a VLAN
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter VLAN view.
vlan
vlan-id N/A
3. Set the aging timer for
dynamic router ports in the
VLAN.
igmp-snooping
router-aging-time
interval
The default setting is 260
seconds.
4. Set the aging timer for
igmp-snooping host-aging-time
The default setting is 260

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English