HPE FlexNetwork 5130 EI Series Configuration Guide

25
Configuring a multicast group policy globally
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IGMP-snooping view.
igmp-snooping
N/A
3. Configure a multicast group
policy globally.
group-policy
acl-number [
vlan
vlan-list ]
By default, no multicast group
policies exist. Hosts can join all
multicast groups.
Configuring a multicast group policy on a port
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface
interface-type
interface-number
N/A
3. Configure a multicast group
policy on the port.
igmp-snooping group-policy
acl-number [
vlan
vlan-list ]
By default, no multicast group
policies exist. Hosts can join all
multicast groups.
Configuring multicast source port filtering
This feature enables the switch to discard all multicast data packets and to accept multicast protocol
packets. You can enable this feature on ports that connect only to multicast receivers.
You can enable this feature for the specified ports in IGMP-snooping view or for a port in interface
view. For a port, the configuration in interface view has the same priority as the configuration in
IGMP-snooping view, and the most recent configuration takes effect.
Configuring multicast source port filtering globally
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IGMP-snooping view.
igmp-snooping
N/A
3. Enable multicast source port
filtering.
source-deny port
interface-list
By default, multicast source port
filtering is disabled.
Configuring multicast source port filtering on a port
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2 Ethernet
interface view.
interface
interface-type
interface-number
N/A
3. Enable multicast source port
filtering.
igmp-snooping source-deny
By default, the multicast source
port filtering is disabled.
Enabling dropping unknown multicast data
This feature enables the switch to drop all unknown multicast data. Unknown multicast data refers to
multicast data for which no forwarding entries exist in the IGMP snooping forwarding table.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English