7
Installing the switch in a 19-inch rack
Installation methods
Table 5 Installation methods for the HPE 5130 HI switches
Chassis
Installation
methods
Installation requirements
Installation
procedure
• HPE 5130 24G
4SFP+ 1-slot HI
• HPE 5130 48G
4SFP+ 1-slot HI
Using front
mounting
brackets
The mounting bracket kit can be
installed on the port side, power supply
side, or the mid-mounting position.
See "Rack-mounting by
usin
g front mounting
brackets."
• HPE 5130 24G
PoE+ 4SFP+
1-slot HI
• HPE 5130 48G
PoE+ 4SFP+
1-slot HI
Using front
mounting
brackets
The front mounting bracket kit must be
installed on the mid-mounting position.
See "Rack-mounting by
usin
g front mounting
brackets."
Using front and
rear mounting
brackets
• The mounting bracket kit can be
installed on the port side or power
supply side.
• Install the rear mounting brackets
according to the rack depth.
{ If the rack depth is in the
range of 429 to 595 mm
(16.89 to 23.43 in), orient the
bracket with the wide flange
inside the rack.
{ If the rack depth is in the
range of 274 to 440 mm
(10.79 to 17.32 in) and the
distance from the rear rack
posts to the inner surface of
the cabinet door is longer than
153 mm (6.02 in), orient the
bracket with the wide flange
outside the rack.
See "Rack-mounting by
usin
g front and rear
mounting brackets
(HPE 5130 24G PoE+
4SFP+ 1-slot HI and
HPE 5130 48G PoE+
4SFP+ 1-slot HI)."
Figure 2 Rack-mounting procedure by using the front mounting brackets
Figure 3 Rack-mounting procedure by using the front and rear mounting brackets
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf, slide the switch to an appropriate
location, and attach the switch to the rack by using the mounting brackets.
To Next Page
Loading...
