HPE JH323A

52
Power supply Specifications Reference
PSR150-D/PSR150-D1
(JD366A/JD366B)
• Rated input voltage range: –48 VDC
to –60 VDC
• Max input voltage range: –36 VDC to
–72 VDC
• Max output power: 150 W
HPE PSR150-A & PSR150-D
Power Supplies User Guide
PSR720-56A (JG544A)
• Rated input voltage range: 100 VAC
to 240 VAC @ 50 Hz or 60 Hz
• Max input voltage range: 90 VAC to
264 VAC @ 47 Hz to 63 Hz
• Max output power: 720 W
HPE PSR720-56A Power Supply
User Guide
PSR1110-56A (JG545A)
• Rated input voltage range: 115 VAC
to 240 VAC @ 50 Hz or 60 Hz
• Max input voltage range: 102.5 VAC
to 264 VAC @ 47 Hz to 63 Hz
• Max output power: 1110 W
HPE PSR1110-56A Power Supply
User Guide
NOTE:
The PSR1110-56A (JG545A) power supply adds 64 mm (2.52 in) to the depth of the switch,
including the depth of the power supply handle.
Hot swappable interface cards
The switch provides an interface card slot at the rear. The following table describes the interface
cards available for the switch.
Card model Port type and quantity
Available transceiver modules and
cables
LSWM2SP2PM 2 × 1/10 Gbps SFP+ fiber ports See Table 16, Table 17, and Table 18.
LSWM2XGT2PM 2 × 1/10GBase-T Ethernet ports N/A
NOTE:
After you install the LSWM2SP2PM and LSWM2XGT2PM interface cards on the switch, the ports on
the interface cards can operate only in 10 Gbps.
For more information about these interface cards, see user manuals for the interface cards.
The LSWM2XGT2PM interface card provides copper ports. To connect cables to the copper ports on
the LSWM2XGT2PM interface card, follow these guidelines:
• Use Category-6A or above cables and connectors. The max transmission distance varies by
cable type:
{ Category-6 UTP—55 m (180.45 ft).
{ Category-6 STP—100 m (328.084 ft), no interference.
{ Category-6 SFTP—100 m (328.084 ft).
{ Category-6A and above twisted pair—100 m (328.084 ft).
• Do not bundle cables in their first 20 m (65.62 ft).
• Separate power cords and twisted pair cables at and around the distribution frame.
• For ports adjacent to one another on the device, the peer ports on the distribution frame is
preferably not adjacent, for example: