HPE JH323A

59
LED for the port LED mode (MODE)
To show more information about the switch through the port LEDs, the switch provides a MODE LED
to indicate the type of information that the port LEDs are showing.
You can use the LED mode switching button to change the indication of the MODE LED.
Table 21 Description for the MODE LED
LED mark Status Description
MODE
Steady green
The port status LEDs are showing
port rates.
Flashing green (1 Hz) (available only for HPE 5130
24G PoE+ 4SFP+ 1-slot HI and HPE 5130 48G
PoE+ 4SFP+ 1-slot HI switches)
The port status LEDs are showing
the status of PoE power supply on
the ports.
Flashing yellow
The port status LEDs indicates the
IRF member ID of the switch. For
example, if the ports 1 to 5 are
steady green, the IRF member ID
of the switch is 5.
10/100/1000Base-T autosensing Ethernet port LED
The switch provides a status LED for each 10/100/1000Base-T autosensing Ethernet port. The port
status LED and the MODE LED indicate the operating state of the 10/100/1000Base-T autosensing
Ethernet port in conjunction.
Table 22 10/100/1000Base-T autosensing Ethernet port LED description
Port mode LED (Mode) status Port LED status Description
Steady green (rate mode)
Steady green
The port is operating at 1000
Mbps. The port LED fast flashes
when the port is sending or
receiving data.
Steady yellow
The port is operating at 10/100
Mbps. The port LED fast flashes
when the port is sending or
receiving data.
Flashing yellow (3
Hz)
POST has failed on the port.
Off No link is present on the port.
Flashing green (1 Hz) (PoE mode, available only
for HPE 5130 24G PoE+ 4SFP+ 1-slot HI and HPE
5130 48G PoE+ 4SFP+ 1-slot HI switches)
Steady green PoE power supply is normal.
Flashing green (3
Hz)
The device attached to the port
requires power higher than the
maximum or currently available
PoE output power on the port.
Steady yellow
The port is experiencing a PoE
failure.
Flashing yellow (3
Hz)
POST has failed on the port.
Off
The port is not supplying PoE
power.