HPE JH323A

60
Port mode LED (Mode) status Port LED status Description
Flashing yellow (IRF mode) Steady green
The port status LED indicates
the IRF member ID of the
switch. For example, if the ports
1 to 5 are steady green, the IRF
member ID of the switch is 5.
SFP+ port LED
Table 23 SFP+ port LED description
SFP+ port LED
status
Description
Steady green
The port is operating at 10 Gbps. The port LED fast flashes when the port is
sending or receiving data.
Steady yellow
The port is operating at 1 Gbps. The port LED fast flashes when the port is
sending or receiving data.
Flashing yellow (3 Hz) POST has failed on the port.
Off
• No link is present on the port.
• The MODE LED operates in IRF mode.
• The MODE LED operates in PoE mode (for PoE switches only.)
Management Ethernet port LEDs
The switch provides an ACT/LINK LED to indicate the operating state of the management Ethernet
port.
Table 24 Management Ethernet port LED description
Management Ethernet
port LED (ACT/LINK)
status
Description
Green The port is up.
Yellow The port is sending or receiving data.
Flashing yellow (3 Hz) The port has failed POST.
Off No link is present on the port.
Interface card status LED
The switch provides an interface card slot at the rear. The interface card status LED on the front
panel indicates the operating state of the interface card.
Table 25 Interface card status LED description
LED mark Status Description
SLOT
Steady green The interface card is in position and is operating correctly.
Flashing yellow
The switch does not support the card model, or the card