Rack mounting optionsRack mounting options
Use the quick-deploy, toolless HPE rack rail option to install the server in a standard four-post server. The rail design supports installation
on server of different mounting interfaces.
For cable management, the rack rail kit might include one or both of the following options:
Rack rail hoop-and-loop strap
Cable management arm
SubtopicsSubtopics
Rail identification markersRail identification markers
Rack mounting interfacesRack mounting interfaces
Rack rail optionsRack rail options
Installing the server into the rackInstalling the server into the rack
Installing the rack rail hook-and-loop strapInstalling the rack rail hook-and-loop strap
Installing the cable management armInstalling the cable management arm
Rail identification markersRail identification markers
The rack rail option support is dependent on these two factors:
The height and weight of the chassis as determined by the front- and rear-end server configurations.
The depth of the chassis as measured from the edge of the front panel (without the front bezel) to the edge of the rear panel.
To ensure compatibility between the rack rails and the server, verify that the rail number labels on the chassis match the ones stamped on
the rails.
Rail number labels on the chassis
To Next Page
Loading...
