Operations 19
2.
Power down the server (on page 17).
3. If a Kensington security cable is installed, disconnect it from the rear panel. See the security cable
documentation for instructions.
4. Place the server on its side.
5. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
6. Place the server on its side.
7. Remove the access panel:
a. Loosen the access panel thumbscrews.
b. Lift the access panel and remove it from the server.
Install the access panel
1. Install the access panel:
a. Place the access panel on the chassis, and slide it towards the front of the server.
To Next Page
Loading...
