Operations 20
b.
Tighten the thumbscrews.
2. Return the server to an upright position.
3. If a Kensington security cable was removed, connect it to the rear panel. See the security cable
documentation for instructions.
4. Connect each power cord to the server.
5. Connect each power cord to the power source.
6. Power up the server (on page 17).
7. Install and lock the tower bezel ("Install the tower bezel" on page 18).
Remove the PCI air baffle
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 17).
2. Power down the server (on page 17).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Place the server on its side.
5. Remove the access panel (on page 18).
To Next Page
Loading...
