Hardware options installation 39
24.
Power up the server (on page 17).
25. Install and lock the tower bezel ("Install the tower bezel" on page 18).
Drive options
When adding drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one drive is used, install it in the bay with the lowest device number.
Drives must be the s
ame capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Installing a hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To install the component:
1. Remove the drive blank.
2. Prepare the drive.
If installing a drive in a server that previously has no drive installed, reboot the server after the new drive
installation. This action enables the drive thermal protection feature. This feature applies to all drives
supported in this server.
•
To Next Page
Loading...
