Operations 22
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.
7. Install and lock the tower bezel ("Install the tower bezel" on page 18).
Remove the system air baffle
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 17).
2. Power down the server (on page 17).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Place the server on its side.
5. Remove the access panel (on page 18).
6. Remove the system air baffle.
Install the system air baffle
CAUTION: For proper cooling do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed.
To Next Page
Loading...
