Hardware options installation 66
a.
Remove the power supply blank.
15. Install a hot-plug power input module in power supply bay 2.
16. Install the access panel (on page 19).
17. Connect the power cords to the power supplies.
18. To prevent accidental power cord disconnection when sliding the server in and out of the chassis,
secure the power cord in the strain relief strap attached to the power input module handle:
a. Unwrap the strain relief strap from the power input module handle.
CAUTION:
Avoid tight bend radii to prevent damaging the internal wires of a power cord or a
server cable. Never bend power cords and server
cables tight enough to cause a crease in the
sheathing.
b. Bend the plug end of the power cord in the position shown in the following image.
To Next Page
Loading...
