Hardware options installation 87
11.
Insert the drive carrier into the media bay until the drive carrier is in locked position.
12. Connect one end of the SATA cable to the rear of the drive and other end of the cable to the system
board.
13. Connect the power cable to the rear of the drive.
14. Install the fans (on page 24).
15. Install the system air baffle (on page 22).
16. If removed, install the PCI air baffle ("PCI air baffle option" on page 57).
17. Install the access panel (on page 19).
18. Return the server to an upright position.
19. Connect each power cord to the server.
20. Connect each power cord to the power source.
21. Power up the server (on page 17).
22. Install and lock the tower bezel ("Install the tower bezel" on page 18).
To Next Page
Loading...
