HPE StoreOnce 3640

7. Return to the License Management screen in the StoreOnce Management Console.
8. Expand the Actions menu ( ), click the Add License icon ( ). and then follow the onscreen
instructions.
Scanning and configuring storage
After storage is added to a StoreOnce System, you must scan and configure the storage to make it
usable.
Procedure
1. On the main menu, select Settings.
2. In the Hardware section, click the Storage panel.
3. On the Storage screen, click the Local Storage tab, and then expand the Actions ( ) menu and
select Rescan.
Newly detected storage is added to the storage list with a status of Unconfigured.
4. To configure the new storage for use, expand the Actions ( ) menu and select Configure.
Checking hardware and firmware
Procedure
1. Navigate to the StoreOnce System and log in to the StoreOnce Management Console.
2. On the main menu, select Settings.
3. In the Hardware section, select the Hardware Monitoring panel.
4. Review the Requires Attention and Storage tabs for any events requiring attention.
5. Expand the Actions ( ) menu and select the Update firmware icon ( ) to check and update
firmware.
Disabling maintenance mode
Procedure
1. From the StoreOnce Management Console main menu, select Settings.
2. In the System section, select the Maintenance mode panel.
3. On the Maintenance mode screen, set the Maintenance mode switch to the Off position ( ),
and then click OK.
Installing capacity upgrade kits 121