HPE StoreOnce 3640

Choose a secure password with at least eight characters that is memorable to you.
c. If the system obtained an IP address through DHCP, it is displayed. To configure a static address
for LAN port 1 (eno1), select the Configure initial network option from the console menu.
Note the DHCP assigned IP address or the static address details.
IP address:______________________________
Prefix length:_____________________________
Gateway:________________________________
DNS:________________________________
You can remove the console display and keyboard.
10. Open a web browser and use the IP address from the previous step to access the StoreOnce
system. The First Time Setup wizard is automatically displayed. Use the First Time Setup wizard to
configure the system for use.
The setup steps include:
• Setting the Administrator Password.
• Setting the Console Password.
• Setting basic System Information such as the system name (host name), location, and contact
information.
• Setting the System Date & Time. You can set the date and time manually, or synchronize the
date and time with a network time server.
• Configuring Storage. The wizard detects the factory installed storage. The wizard also enables
you to configure additional storage capacity that you might have installed. The wizard also reports
issues with additional storage, for example, when additional storage is not installed in the correct
location.
• Configuring Remote Support.
Installing the capacity upgrade enclosures during the
initial system installation
CAUTION: Use extreme caution when installing and pulling units from the rack. Unattached units
can slip and fall, damaging the StoreOnce System or causing personal injury. Hewlett Packard
Enterprise is not responsible for any damage or injury caused by mishandling the StoreOnce
System.
Component Rack space Weight
Capacity upgrade enclosure 2U 26.2 kg (58 lbs)
Always use at least two people to lift and locate an enclosure into the rack.
26 HPE StoreOnce 3640 System