a. Install the rail kit for the StoreOnce server. See the installation instructions that ship with the rail
kit.
b. Insert the two locking nuts for the server into the rack; one on each front column.
c. Install the server into the rack and secure it using the thumbscrews on the front bezel of the
server.
6. Install the storage enclosure rails in the rack.
a. Adjust the back bracket on the standard rail kit so it accommodates the storage enclosure. Attach
rear hold down brackets by sliding the tab with the arrow pointed forward (1) into the
corresponding slot on the left and right side of the rear of the chassis. Use the black headed
thumb screw to secure tightly to the rail in the second hole from the rear (2).
NOTE: It is easier to make this adjustment prior to mounting the rails.
b. Position left and right rack rails at the desired 'U' position in the rack, adjusting the rails to fit the
rack, as needed. Front and Rear bottom edge of rails must align with the bottom of EIA boundary
in the lowermost 'U'.
NOTE: Rails are marked L and R with an arrow indicating the direction in which the rail is
installed.
c. Use guide pins to align the shelf mount kit to the rack column holes.
d. To engage the rear rack rail mount, push the rail toward the back of the rack until the spring hook
snaps into place.
HPE StoreOnce 5250 and 5650 Systems 59
To Next Page
Loading...
