HPE StoreOnce 3640

a. On the main menu, select Settings.
b. In the Security section, click the Certificates panel.
c. On the Certificates screen, select Generate CSR on the Actions menu.
9. Expand storage, if necessary. Capacity upgrades ordered with the system will have already been
configured. If capacity upgrades were ordered separately, configure them now.
a. On the main menu, select Settings.
b. In the Hardware section, click the Storage panel.
c. On the Storage screen, click the Local Storage tab, and then expand the Actions ( ) menu
and select Rescan.
Newly detected storage is added to the storage list with a status of Unconfigured.
d. To configure the new storage for use, expand the Actions ( ) menu and select Configure.
10. Configure Remote Support using STaTS.
For additional information, see StoreOnce Remote Support.
11. Configure Fibre Channel.
For additional information, see Fibre Channel with StoreOnce Systems.
12. Configure iLO, if necessary.
If you plan to use iLO with the system and did not configure it during the system installation,
configure iLO now.
• View or update the iLO configuration from the StoreOnce Management Console.
a. On the main menu, select Settings.
b. In the Hardware section, click the Integrated Lights Out (iLO) Configuration panel.
The Integrated Lights Out (iLO) Configuration screen shows the HPE Integrated Lights Out
network configuration.
• In environments that do not use DHCP, DNS, or WINS, configure a static IP address during
bootup.
a. Restart or power on the StoreOnce Server.
b. Press F9 in the server POST screen.
The UEFI System Utilities start.
c. Navigate to System Configuration > iLO 5 Configuration > Network Options.
d. Configure the iLO network options and note the iLO IP address, iLO subnet mask, and iLO
gateway.
13. The StoreOnce 5250 or 5650 System is now installed and ready for production use.
70 HPE StoreOnce 5250 and 5650 Systems