HPE STOREONCE 5500

IMPORTANT:
If you run the hardware add storage command before the LUN creation process completes,
the amount of time required to complete parity initialization cannot be predicted because it
depends upon the workload of the system. It may take several days to complete and
performance will be impaired.
6. Monitor the expansion using the following command:
hardware show status and hardware show storage status
The following output is an example; the values shown may not match your appliance specific values.
# hardware show status
Name Dev—
id Status
—----—----–—–-–—––-- ----–----—----–—–-–—––------—----–— –—––--–
HPCZ230805V9 31343337–3338–5A43–3233–323330314D38 OK
p1228 Storage System 041f40d4–0000–1000–b00c-533455303039 DEGRADED
#
# hardware show storage status
Storage Set Status
—----—----–—--- ----––
Set 1 Formatted 34,876.99GB, Discovered 37,134.57GB to be added
#
#hardware add storage
This command takes several hours to complete execution
storage addition successfully started
#
# hardware show storage status
Storage Set Status
—----—----–—--- ----––
Set 1 Formatted 34,876.99GB, Adding 37,134.57GB...
#
# system show status
Storage Set Status
—----—----–—--- ----––
Set Formatted 34,876.99GB, Adding 37,134.57GB...
Service Sets Status Notes
------------ ------ -----
Set 1 Running
#
7. Once the storage is available, performance will return to normal as long as parity initialization was
allowed to complete before the hardware add storage command was run.
52 Using the StoreOnce CLI