− 29 −
(3) 供料指的位置调整
1) 用六角扳手 (M4 用 ) 拧松供料指安装螺丝
。(A 方向 )
2) 把供料指
对准传送器的操作孔的中心。
3) 用六角扳手拧紧供料指的安装螺丝
。(B 方向 )
( 注意 ) 拧紧螺丝后，请再次确认供料指的位置。
(4) 传送供料器安装位置的调整
1) 用六角扳手 (M4 用 ) 拧松传送供料器安装螺丝
。(A 方向 )
2) 调整高度，不让从切断钳出来的传送器
与传送供料器
相碰。
然后，调整前后位置，不让夹杆
碰到传送供料器
。
3) 用六角扳手拧紧传送供料器安装螺丝
。(B 方向 )
(3)Adjustingthepositionofthefeednger
1) Loosen feed nger mounting screw
using a hexagonal wrench key (for M4). (direction
A
).
2) Adjust feed nger
to the center of the pilot hole of the carrier.
3) Tighten feed nger mounting screw
with a hexagonal wrench key (direction
B
).
(Caution)Aftertighteningthescrew,checkagainthepositionofthefeednger.
(4) Adjusting the mounting position of the carrier chute
1) Loosen carrier chute mounting screw
using a hexagonal wrench key. (for M4) (direction
A
).
2) Adjust the height so that carrier chute
does not come in contact with carrier
coming out from the cut-o
punch.
Adjust the longitudinal position so that crimper
does not come in contact with carrier chute
.
3) Tighten carrier chute mounting screw
with a hexagonal wrench key (direction
B
).
(5) How to adjust the position of the terminal
(Caution) Adjustment of this terminal position is of up-feed type of the terminal feed.
1) Loosen pivot block xing screw
with the terminal set in position.
2) If terminal
is situated on the left of anvil
, turn the feed adjusting shaft in the direction of arrow
A
. If the
terminal is situated on the right
, turn it in the direction of arrow
B
.
3) Once the terminal is brought to just above
the anvil, tighten xing screw
.
(5) 端子位置的调整方法
( 注意 ) 本端子位置的调整是端子传送的上供料型。
1) 在安装了端子的状态下，请拧松旋转轴锁定固定螺丝
。
2) 端子
在砧台
的左方时，向箭头 A 方向转动传送调整轴，在右方
时，向箭头 B 方向转动。
3) 端子移动到砧台的上方
之后，请拧紧固定螺丝
。
To Next Page
Loading...
