71
28、needle bearing15BM2112 29、M10X16 oil-change bolt 30、10X1.5 cooper gasket 31、
power divider coupling 32、differential-adjusted washer 33、bolt M14X15
34、copper gasket 14X2 35、vent pipe of drive case 36、clip of oil pipe 37、fore
transmission shaft
38、weak spring of fore transmission shaft
39、dust-proof cover of fore transmission shaft
4.4.1 Disassembly, inspection, assembly of Rear Bridge
components(refer to the figure of fore Bridge ,fore case
components)
4.4.1.1
1. Check if the connection between wheel hub and the Bottom Seat
of wheel hub is reliable and if there is any distortion on the
Bottom Seat of wheel hub.If there exists any such potential
defects, the Bottom Seat of wheel hub must be replaced
immediately.
2. Check if the differential and its attachments are compatible well
and if there is stagnation, slosh and
Crunch of the Differential bearing. In case the bearing or
Differential is flawed, the fore bridge must be removed in the
first instance, then replace the bearing and Differential.
3. Check if the constant velocity joint is matched up well. If not so
or there is gear-cracked and abnormal noise, remove the
constant velocity joint and align it .
To Next Page
Loading...