THT45 - THT45W - THT46
Emissivity setting
1. Select the item “Emiss” with the keys or and press the key . The screen Fig.
18 – Central part is shown on the display.
Fig. 18: Setting Emissivity on the instrument
1. Use the keys or to select the item “Emiss” and press the key . The screen Fig.
18 – Right side is shown on the display
2. Use the keys or to select the emissivity values of materials found in the
integrated table and press the key “Select” to confirm your choice.
3. Select the item “Custom” and confirm your custom setting of the emissivity value with
the “Select” key. Use the keys or to set the value in the range: 0.01 1.00
4. Press the “Close” key to confirm your setting and to go back to the initial screen. The
set emissivity value is displayed in the status bar.
Temperature compensation setting
The "Temp. Comp ” parameter allows to set a positive or negative compensation value
which is added or subtracted from that the temperature measured only in the Screening
function (see §)
1. Select the item “Emiss” with the keys or and press the key . The screen Fig.
19 – Central part is shown on the display.
Fig. 19: Setting temperature compensation on the instrument
To Next Page
Loading...