THT45 - THT45W - THT46
5.3 SAVING THE IMAGE ON THE DISPLAY
1. Insert the micro SD card into the relevant slot of the instrument (see Fig. 4). The icon
“ ” is shown in the top left-hand part of the display.
2. Select the desired image display mode (see § 5.2.4).
3. Press the T (Trigger) key to freeze the image shown on the display (see Fig. 29).
4. Press the “Save” key to definitively save the image. The message “Save YYYYMMDD
_xxxx.jpg” appears for a moment on the display (“YYYYMMDD” indicates the year,
month and day in which the image was saved while “xxxx” indicates the sequence
number of the image saved).
Fig. 29: Saving the image on the display
5. Press the “Cancel” key to exit without saving.
5.4 RECORDING A VIDEO ON THE DISPLAY
1. Insert the micro SD card into the relevant slot of the instrument (see Fig. 4). The icon
“ ” is shown in the top left-hand part of the display.
2. If necessary, insert the jack of the headphones into the camera (see Fig. 2 – Part 17).
3. Select the desired image display mode (see § 5.2.4).
4. Press and hold the T (Trigger) key for some seconds to activate video recording. The
message “YYYYMMDD _xxxx.mp4” appears in the status bar and the timer appears at
the bottom of the display (see Fig. 30)
Fig. 30: Video recording
5. Talk into the microphone as long as you desire.
6. Press the T (Trigger) key again to stop the video
7. Press the “Save” kay to save the video or the “Cancel” key to exit without saving.
To Next Page
Loading...