Configuration Roadmap
1. Connect a PC to the router through a console port.
2. Perform login settings on the PC.
3. Log in to the router.
NOTE
In this example, a terminal emulator is used.
Data Preparation
Communication parameters of the PC (baud rate: 4800 bps, data bit: 6, parity: even, stop bit: 2,
flow control mode: none)
Procedure
Step 1 Establish the configuration environment by connecting the serial port of the PC to the console
port of the router through standard RS-232 cable.
Step 2 Start a terminal emulator on the PC, and set the communication parameters of the PC, as shown
in Figure 5-2 to Figure 5-4.
Figure 5-2 Connection creation
Huawei AR2200 Series Enterprise Routers
Configuration Guide - Basic Configuration 5 Configuring User Login
Issue 02 (2011-10-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
77
To Next Page
Loading...
