13
Table 3-1 Service modes of the HG520s
Service Mode Working Method Configuration
Bridge
z Take the HG520s as bridge
equipment.
z Use the PPPoE dial-up software
of the computer for dialing.
Refer to
3.3
"Configuring
the Bridge
Mode
."
PPPoE
z Take the HG520s as a router.
z Use the embedded PPPoE
dial-up software of the HG520s
for dialing.
z Use the PPPoE encapsulation
mode to encapsulate the
packets.
Refer to
3.4
"Configuring
the PPPoE
Mode
."
PPPoA
z Take the HG520s as a router.
z Use the PPPoA dial-up software
of the HG520s for dialing.
z Use the PPPoA encapsulation
mode to encapsulate the
packets.
Refer to 3.5
"Configuring
the PPPoA
mode
."
RFC2684B
z Take the HG520s as a router.
z Use the static IP address or the
IP address dynamically allocated
by the ISP.
z Use the IPoE/IPoA
encapsulation mode to
encapsulate the packets.
Refer to
3.6
"Configuring
the RFC2684B
Mode
."
RFC2684 (IPoA)
z Take the HG520s as a router.
z The HG520s uses the static
public IP address to access the
Internet.
z Use the IPoA encapsulation
mode to encapsulate the
packets.
Refer to
3.7
"Configuring
the RFC2684
(IPoA) Mode
."
Note:
ISP = Internet Service Provider
IPoA = Internet Protocol over ATM