18
3.4.2 Steps
1. Configuring the HG520s
Follow the steps described as follows:
(1) Log in to the Web configuration page. For the procedure,
refer to
2.2 (4)"2.3 ."
(2) Select Basic > WAN Setting in the navigation tree to
display the WAN configuration page.
(3) In the WAN configuration page, select the PVC that needs to
be configured.
(4) Set Mode to Routing.
(5) Set Encapsulation to PPPoE. Configure the relevant
parameters in
Figure 3-3 according to the values in the
Table 3-3.
To Next Page
Loading...
