14
Caution:
Some parameters are validated only after they are saved and the
HG520s is rebooted. Follow the prompt in the configuration page to
perform this operation.
3.3 Configuring the Bridge Mode
In the bridge mode, the HG520s serves as a bridge. You need to
install the Point to Point Protocol (PPP) dial-up software to realize the
dial-up access to the Internet.
This section describes the process to configure the HG520s to
work in the bridge mode and the process to configure your computer to
access the Internet through the HG520s.
3.3.1 Preparation
Table 3-2 shows the configuration for the bridge mode.
Table 3-2 Configuration for the bridge mode
Name Configuration
PVC mode Bridge
Encapsulation RFC2684
VPI/VCI Provided by the ISP
Multiplex Provided by the ISP
PPP dial-up software
Install the PPP dial-up software on your
computer to access the Internet (The
Windows XP operating system is provided
with the PPP dial-up software)
Username and password for
the PPPoE dial-up
Provided by the ISP
To Next Page
Loading...
Need help?
General