Parameter Description Setting
Date format Specifies the format in which the date is
displayed.
The default value is YYYY/
MM/DD.
Enable NTP Specifies whether your TE30
automatically synchronizes system time
with a Network Time Protocol (NTP)
server at an interval of 300 seconds.
NOTE
If you set this parameter to Enable NTP,
you must also set NTP server address.
This parameter is deselected by
default.
NTP address
type
Specifies the mode for your TE30 to
obtain the Network Time Protocol
(NTP) server IP address.
l Auto: Your TE30 automatically
obtains the NTP server IP address.
l Manual: You must manually set the
NTP server IP address.
This parameter is available only when
Connection type is set to Dynamic
IP.
NOTE
For details about how to set Connection
type, see 3.1 Setting IP Parameters.
The default value is Manual.
NTP server
address
Specifies the NTP server IP address. No default value is set for this
parameter.
To set the Fan noise parameter, Choose Advanced Settings > Settings > General > Fan
noise。
l Quiet: The noise level is minimal, and the rotation speed is slow.
l Cozy: The noise level is medium, and the rotation speed is normal.
To set custom parameters listed in Table 2-5, choose Advanced Settings > Settings >
Display > Personalize.
HUAWEI TE30 Videoconferencing Endpoint
User Guide 2 Installation and Initial Configuration
Issue 01 (2013-03-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9
To Next Page
Loading...
Need help?
General
