Parameter Description Setting
Conference line
type
Specifies the type of line used
during a conference.
If you select Auto and your TE30
has registered with a network
gatekeeper (GK), your TE30
preferentially uses H.323 to initiate
a conference.
The default value is Auto.
Conference
bandwidth
Specifies the transmission
bandwidth for a conference.
If your TE30 accesses an E1
network through an IP line, set this
parameter to Limited for better
conference video quality.
The default value is Normal.
Dynamic
bandwidth
Specifies whether the TE30
implements the following if the
packet loss rate increases due to
insufficient network bandwidth:
The TE30 automatically decreases
the conference bandwidth until
constant packet loss no longer
occurs or the conference bandwidth
is decreased to 64 kbit/s. If constant
packet loss is detected, the TE30
dynamically adjusts bandwidth to
recover stable conference quality
within 1 minute.
This parameter is deselected by
default.
l When the network is running
properly, do not select this
parameter.
l When the network is not running
properly, select this parameter.
reserved
presentation
bandwidth
Disable this parameter if your site is
not going to send or receive
presentations during a conference
and the Received value for
Presentation bandwidth [frame
rate] is not -.
If this parameter is disabled, the
Received value for Presentation
bandwidth [frame rate] restores to
- when you rejoin the conference.
NOTE
To view the Presentation bandwidth
[frame rate] value, choose Advanced
> Diagnostics > Status >
Conference.
The default value is Enable.
Preferred IP
protocol
Specifies the protocol that IP sites
preferentially use.
When Line type is set to Auto for
IP sites, your TE30 uses this
protocol to call the IP sites.
The default value is H.323.
HUAWEI TE30 Videoconferencing Endpoint
User Guide 6 Conference
Issue 01 (2013-03-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
50
To Next Page
Loading...
Need help?
General
