Huawei FusionModule5000 User Manual

Parameter Description Setting
Network
interface
mode
Specifies the working mode for the
network ports on your TE30.
l Auto detection: When accessing a
network, your TE30 automatically
negotiates with a remote network
device to determine the optimal work
mode.
l 10 Mbps and half duplex: The data
transmission rate is 10 Mbit/s, and data
cannot be sent and received
simultaneously.
l 10 Mbps and full duplex: The data
transmission rate is 10 Mbit/s, and data
can be sent and received
simultaneously.
l 100 Mbps and half duplex: The data
transmission rate is 100 Mbit/s, and
data cannot be sent and received
simultaneously.
l 100 Mbps and full duplex: The data
transmission rate is 100 Mbit/s, and
data can be sent and received
simultaneously.
The default value is
Auto
detection.
NOTE
If the remote network device you
want to communicate with has its
network interface mode set to 10
Mbps and full duplex or 100
Mbps and full duplex, set this
parameter to be the same as the
remote network interface mode.
Otherwise, communication fails.
PPPoE
Specifies whether your TE30 accesses
broadband networks using dial-up
connections.
NOTE
If you set this parameter to Enable, you must
also set Dialing mode, User name, and
Password.
The default value is Disable.
HUAWEI TE30 Videoconferencing Endpoint
User Guide 3 Network
Issue 01 (2013-03-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13

Huawei FusionModule5000 Specifications

General

Brand	Huawei
Model	FusionModule5000
Category	Wireless Router
Language	English