Huawei FusionServer Pro 2298 V5 - Page 10

● The trusted platform module (TPM) and trusted cryptography module (TCM)
provide advanced encryption functions, such as digital signatures and remote
authentication.
NO TE
The service port with NC-SI enabled supports the following conguration:
● Conguring any port on the LOM, OCP 2.0 mezzanine card 1, or PCIe NIC as the service
port with NC-SI enabled. Host port 1 is congured by default.
● Enabling, disabling, and setting a virtual local area network (VLAN) ID for this port. The
VLAN ID is 0 and disabled by default.
●
Conguring IPv4 addresses (IPv4 address, subnet mask, and gateway) and IPv6
addresses (IPv6 address, prex length, and gateway) for this port.
Energy Eciency
● The 80 Plus Platinum power supply units (PSUs) of multiple power ratings
provide 94% power eciency at 50% load.
● The server supports active/standby power supplies and high-voltage DC
(HVDC) for improved power supply
eciency.
● Ecient voltage regulator-down (VRD) power supplies for boards minimize
the energy loss from DC/DC power conversion.
● Area-based, Proportional-Integral-Derivative (PID) intelligent fan speed
adjustment and intelligent CPU frequency scaling optimize heat dissipation
and reduce overall system power consumption.
● The improved thermal design with
energy-ecient fans ensures optimal heat
dissipation and reduces system power consumption.
● The server is protected with power capping and power control measures.
● Staggered spin-up for drives reduces the server boot power consumption.
● Intel® Intelligent Power Capability allows a processor to be powered on or
o
based on requirements.
● Low-voltage Intel
®
Xeon
®
Scalable processors consume less energy, ideally
suited for data centers and telecommunications environments constrained by
power and thermal limitations.
● SSDs consume 80% less power than HDDs.
Huawei FusionServer Pro 2298 V5 Server
Technical White Paper 2 Features
Issue 05 (2020-09-03) Copyright © Huawei Technologies Co., Ltd. 4