1 PSU indicator 2 UID indicator
3 Serial port indicators
NOTE
The indicators are reserved.
4 Connection status
indicator for the
management network
port
5 Data transmission status
indicator of the
management network
port
6 LOM indicators
7 OCP 2.0 mezzanine card
indicators
- -
Indicator Description
Table 5-3 Indicators on the rear panel
Indicator Description
PSU indicator ● O: No power is supplied.
● Blinking green at 1 Hz:
– The input is normal, and the server is standby.
– The input is overvoltage or undervoltage.
– The PSU is in deep hibernation mode.
● Blinking green at 4 Hz: The
rmware is being
upgraded online.
● Steady green: The power input and output are
normal.
● Steady orange: The input is normal, but no power
output is supplied.
NOTE
The possible causes of no power output are as follows:
● Power supply overtemperature protection
● Power output overcurrent or short-circuit
● Output overvoltage
● Short-circuit protection
● Device failure (excluding failure of all devices)
Huawei FusionServer Pro 2298 V5 Server
Technical White Paper 5 Hardware Description
Issue 05 (2020-09-03) Copyright © Huawei Technologies Co., Ltd. 14
To Next Page
Loading...
