2. Select the new device, choose Running Param. > Adjustment, and set Adjust
total energy yield and Calibration of total power supply from grid to be
the same as those of the original device.
Figure 9-24 Energy yield calibration
Step 6 After the topology is identied successfully, update the Smart PCS software.
Ensure that the software version of the new Smart PCS is the same as that of the
running Smart PCS on site.
Step 7 View the running status of the Smart PCS to check whether the Smart PCS
functions properly.
Step 8 Delete the faulty Smart PCS.
Choose Maintenance > Connect Device, select the faulty Smart PCS, click
Remove Devices, and click Conrm.
Figure 9-25 Deleting a device
Step 9 (Optional) Log in to the Smart PV Management System, enter the PV plant, click
Device Management, select the faulty Smart PCS, click Delete, and click OK.
LUNA2000-200KTL-H0 Smart Power Control System
User Manual 9 Device Maintenance
Issue 05 (2022-06-30) Copyright © Huawei Technologies Co., Ltd. 84
To Next Page
Loading...