It is recommended that silica gel or paint be used around the ground terminal after the PE
cable is connected.
Step 1 Connect the PE cable to the battery power control modules and battery expansion
modules.
Figure 5-2 Connecting the internal PE cable
----End
5.2.2 Installing Internal DC Terminals
Step 1 Insert the positive and negative connectors delivered with the battery into the
positive and negative battery cascading terminals (B+ and B–).
LUNA2000-(5-30)-S0
User Manual 5 Electrical Connection
Issue 01 (2020-10-20) Copyright © Huawei Technologies Co., Ltd. 51
To Next Page
Loading...
