Huawei LUNA2000 - Connecting Internal Signal Cables

Figure 5-3 DC power cable connection inside the battery
NO TE
The DC terminals between the power control module and the battery expansion modules
use the DC connection cable (Amphenol terminal) delivered with the battery.
NO TICE
After the positive and negative connectors snap into place, pull the DC input
power cables back to ensure that they are connected securely.
----End
5.2.3 Connecting Internal Signal Cables
Connecting Signal Cables Between the Power Control Module and Battery
Expansion Modules
Connect the communications terminals of the power control module and battery
expansion modules in sequence and secure them using cable clips.
LUNA2000-(5-30)-S0
User Manual 5 Electrical Connection
Issue 01 (2020-10-20) Copyright © Huawei Technologies Co., Ltd. 52