Huawei LUNA2000 - Forced Charge and Discharge

6.2 System Power-On
NO TICE
After turning on the battery switch, power on the inverter. For details about how
to power on the inverter, see the quick guide for the corresponding inverter model.
NO TE
If no PV module is congured, press the black start button rst.
Turn on the DC switch on the battery. After the battery is installed and powered
on for the rst time, the ring LED blinks for three circles. Observe the battery
indicator to check the running status.
LED Indicators
LED indicator description
Table 6-2 LED indicators
Category
Status (Blinking at Long
Intervals: On for 1s and then
O for 1s; Blinking at Short
Intervals: On for 0.2s and
then O for 0.2s)
Description
Running indicator N/A
Steady
green
Steady green Operating mode
Blinking
green slowly
Blinking green
slowly
Standby mode
O O Hibernation mode
Blinking red
fast
N/A Power control module environment alarm
N/A Blinking red
fast
Battery expansion module environment
alarm
Steady red N/A The power control module is faulty.
N/A Steady red The battery expansion module is faulty.
Steady red Steady red Faulty
Battery system
indicator
N/A
LUNA2000-(5-30)-S0
User Manual 6 System Commissioning
Issue 01 (2020-10-20) Copyright © Huawei Technologies Co., Ltd. 65