Huawei LUNA2000 - Installing a PE Cable

Figure 5-5 Rout
ing cables out of the cable hole
NO TICE
Before connecting external cables, route the cables through the cable hole to
av
oid disconnecting after installation.
5.3.1 Installing a PE Cable
Pr
ecautions
D ANGER
Ensure that the PE cable is securely connected. Otherwise,
electric shocks may
occur.
NO TE
It is recommended that silica gel or paint be used around the ground terminal after the
PE cable is connected.
Procedure
Step 1 Crimp an OT terminal.
NO TICE
● Avoid scratching the core wire when stripping a cable.
●
The cavity formed after the conductor crimp strip of the OT terminal is crimped
must wrap the core wires completely. The core wires must contact the OT
terminal closely.
● Wrap the wire crimping area with heat shrink tubing or insulation tape. The
heat shrink tubing is used as an example.
● When using a heat gun, protect the equipment from being scorched.
LUNA2000-(5-30)-S0
User Manual 5 Electrical Connection
Issue 01 (2020-10-20) Copyright © Huawei Technologies Co., Ltd. 54