Figure 5-6 Crimping an O
T terminal
(A) Core wire (B) Insulation layer (C) Heat shrink tubing
(D) Heat gun (E) Hydraulic pliers
Step 2 Connect the gr
ound point of the power control module to the external ground
point.
Figure 5-7 Grounding the PE cable
It is recommended that silica gel or paint be used around the ground terminal after the
PE cable is connected.
----End
LUNA2000-(5-30)-S0
User Manual 5 Electrical Connection
Issue 01 (2020-10-20) Copyright © Huawei Technologies Co., Ltd. 55
To Next Page
Loading...
