EasyManua.ls Logo

Huawei S6700 Series

Huawei S6700 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Step 2 Run the interface vlanif vlan-id command to enter the VLANIF interface view.
Step 3 Run the ip binding vpn-instance vpn-instance-name command to bind the VPN instance to a
VLANIF interface.
By default, a VLANIF interface is not bound to any VPN instance.
NOTE
The ip binding vpn-instance command deletes Layer 3 features such as the IP address and routing
protocols configured on the interface. To use these features, you need to reconfigure them.
Step 4 Run the ip address ip-address { mask | mask-length } command to assign an IP address to the
VLANIF interface.
----End
11.3.4 Checking the Configuration
Run the display ip vpn-instance [ verbose ] [ vpn-instance-name ] command to view
information about a VPN instance..
Run the display ip vpn-instance command. If the configuration is correct, you can view:
l VPN instance created correctly
l Name of the VPN instance
l RD
l Description
l Maximum number of routes supported by the VPN instance
l Interface configured correctly
11.4 Configuring a Route Multi-Instance Between an MCE
and a Site
This section describes how to configure static routes, RIP, OSPF, IS-IS, and BGP between an
MCE and a site.
For configuring a route multi-instance between an MCE and a site,11.4.2 (Optional)
Configuring a Static Route Between an MCE and a Site to 11.4.6 (Optional) Configuring
BGP Between an MCE and a Site are optional and can be configured as required.
11.4.1 Establishing the Configuration Task
Applicable Environment
To connect a CE to multiple VPNs and isolate services of these VPNs, you need to configure
MCE functions. Before configuring MCE functions, you need to perform the task of 11.3
Configuring a VPN Instance on the MCE and PE and then configure a route multi-instance
between an MCE and a site.
Pre-configuration Tasks
Before configuring a route multi-instance between an MCE and a site, complete the following
task:
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 11 MCE Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
632

Table of Contents

Other manuals for Huawei S6700 Series

Related product manuals