Prerequisites
The configurations of controlling the receiving of RIPng routing information are complete.
Procedure
l Run the display ripng process-id database command to check all activated routes in the
RIPng database.
l Run the display ripng process-id route command to check all the RIPng routes that are
learned from other switchs.
----End
3.7 Optimizing a RIPng Network
You can adjust and optimize the RIPng network performance by configuring RIPng timers, split
horizon, poison reverse, and zero field check.
3.7.1 Establishing the Configuration Task
Before adjusting and optimizing the RIPng network performance, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the data required for
the configuration. This will help you complete the configuration task quickly and accurately.
Applicable Environment
On certain networks, you need to configure RIPng features and optimize the performance of a
RIPng network. After performing configuration procedures in this section, you can:
l Change the convergence speed of the RIPng network by adjusting RIPng timers.
l Configure split horizon and poison reverse to prevent routing loops.
Pre-configuration Tasks
Before optimizing a RIPng network, complete the following tasks:
l Configuring IPv6 addresses for interfaces to ensure that neighboring nodes are reachable
at the network layer
l Configuring Basic RIPng Functions
Data Preparation
To optimize a RIPng network, you need the following data.
No.
Data
1 Values of timers
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 3 RIPng Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
72
To Next Page
Loading...
Need help?
General
