Huawei S6700 Series

#
interface Vlanif10
ip address 1.1.1.1 255.255.255.0
#
interface XGigabitEthernet0/0/1
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
ospf 1
opaque-capability enable
graceful-restart
area 0.0.0.0
network 1.1.1.0 0.0.0.255
#
return
l Configuration file of Switch B
#
sysname SwitchB
#
router id 2.2.2.2
#
vlan batch 10
#
interface Vlanif10
ip address 1.1.1.2 255.255.255.0
#
interface XGigabitEthernet0/0/1
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
ospf 1
opaque-capability enable
graceful-restart
area 0.0.0.0
network 1.1.1.0 0.0.0.255
#
return
4.14.7 Example for Configuring OSPF-BGP
Network Requirements
As shown in Figure 4-11, all switches run BGP. An EBGP connection is established between
Switch D and Switch E. IBGP full connections are established between partial switches in AS
10, and OSPF is used as an IGP protocol.
It is required to enable OSPF-BGP linkage on Switch B so that the traffic from Switch A to AS
20 is not interrupted after Switch B restarts.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 4 OSPF Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
164