EasyManua.ls Logo

Huawei S6700 Series

Huawei S6700 Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Procedure
Step 1 Run the system-view command to enter the system view.
Step 2 Run the ip route-static vpn-instance vpn-source-name destination-address { mask | mask-
length }{ interface-type interface-number [ gateway-address ] | vpn-instance vpn-destination-
name gateway-address | gateway-address } [ preference preference ] [ track bfd-session cfg-
name ] [ description description ] command to configure a static route to a PE.
You must specify the next hop address on the local device.
----End
11.5.3 (Optional) Configuring RIP Between an MCE and a PE
Context
Do as follows on the MCE.
You need to perform similar configurations on a PE. For details, refer to manuals of
corresponding products.
Procedure
Step 1 Run the system-view command to enter the system view.
Step 2 Run the rip [ process-id ] vpn-instance vpn-instance-name command to create and enable a
RIP process used by a VPN instance and enter the RIP view.
Step 3 Run the network network-address command to enable RIP routes on the network segment where
the IP address of the VLANIF interface bound to the VPN instance belongs.
Step 4 (Optional) Run the import-route { { static | direct } | { { rip | ospf | isis } [ process-id ] } }
[ cost cost | route-policy route-policy-name ]
*
command to import routes from other routing
protocols.
If another routing protocol is run between an MCE and a site in this VPN, you need to perform
this step.
----End
11.5.4 (Optional) Configuring OSPF Between an MCE and a PE
Context
Do as follows on the MCE.
You need to perform similar configurations on a PE. For details, refer to manuals of
corresponding products.
Procedure
Step 1 Run the system-view command to enter the system view.
Step 2 Run the ospf [ process-id | router-id router-id | vpn-instance vpn-instance-name ]
*
command
to create an OSPF process used by a VPN instance and enter the OSPF view.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 11 MCE Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
638

Table of Contents

Other manuals for Huawei S6700 Series

Related product manuals