Huawei S6700 Series

Context
Do as follows on the switch that runs OSPF:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospf [ process-id ]
An OSPF process is enabled and the OSPF view is displayed.
Step 3 Run:
filter-policy { acl-number | acl-name acl-name | ip-prefix ip-prefix-name } import
The filtering policy is configured for routes received by OSPF.
----End
10.5.4 Filtering Routes Received by IS-IS
By applying filters, you can control the receiving of IS-IS routes.
Context
Do as follows on the switch that runs IS-IS:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
isis [ process-id ] [ vpn-instance vpn-instance-name ]
An IS-IS process is enabled and the IS-IS view is displayed.
Step 3 Run:
filter-policy { acl-number | acl-name acl-name | ip-prefix ip-prefix-name | route-
policy route-policy-name } import
You can configure IS-IS to filter the received routes to be added to the IP routing table.
----End
10.5.5 Filtering Routes Received by BGP
By applying filters, you can control the receiving of BGP routes.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 10 Routing Policy Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
604