Huawei SmartLi-ESM-24020P1 - Page 19

Figure 1-8 Installing the mounting ears that are reversely assembled
Step 4 Remove the wiring cover.
Figure 1-9 Removing the wiring cover
Step 5 Assign two persons to hold the handles on both sides, one hand holding the inner
handle and the other holding the outer handle, and assign another person to hold
the bottom of the battery module from the front to lift the module onto the guide
rails and slowly insert it into the rack.
Figure 1-10 Lifting the module onto the guide rails and pushing it
Step 6 When the inner handle is about to enter the door beam, assign the two persons to
release the inner handle with one hand, fasten the inner handle properly, and hold
the side bottom of the battery module, and hold the outer handle with the other
hand to continue to insert the module slowly.
SmartLi-ESM-24020P1
Quick Guide 1 Installation and Cable Connection
Issue 03 (2022-12-30) Copyright © Huawei Digital Power Technologies Co., Ltd. 13