● If the rack depth is between 600 mm and 700 mm, the battery module may not be
completely pushed into the rack due to mounting ears. In this case, install the mounting
ears reversely and perform Step 1 to Step 9. The mounting ears of a BBB box also need
to be installed reversely.
● If the rack depth is greater than 700 mm, install the mounting ears directly and perform
Step 4 to Step 9.
Step 1 Remove the mounting ears.
Figure 1-6 Removing mounting ears
Step 2 Assemble the mounting ears reversely.
1. Separate the mounting ears with handles from the front of the washer.
2. Turn over the washer so that the rear of the washer faces forward.
3. Install the mounting ears with handles to the rear of the washer.
Figure 1-7 Assembling the mounting ears reversely
(1) Mounting ears with
handles
(2) Front of the washer (3) Rear of the washer
Step 3 Install the mounting ears reversely assembled onto the battery module.
SmartLi-ESM-24020P1
Quick Guide 1 Installation and Cable Connection
Issue 03 (2022-12-30) Copyright © Huawei Digital Power Technologies Co., Ltd. 12
To Next Page
Loading...
